RC Joystick NG² Hardware (new design with single layer PCB, requires firmware >= 3.3.3) RC Joystick NG² SMD RC Joystick NG² Through Hole RC Joystick NG² Eagle LE Project On this page you can find a little project to build an interface to connect a Radio Controller Trasmitter to your computer via USB. With this interface your favourite RC or flight simulator will see the RC TX as two traditional joysticks with a total of 16 analog axes (up to about 5000 levels resolution each) and 16 buttons.  Assignments of joystick controls to radio channels are reprogrammable via software through USB (binaries for Windows and Linux). The interface use the new flash USB chips from microchip PIC18F2455/2550 and can now be programmed also via USB with our qpicprog software. Can read PPM, PCM or directly pots/switches through ADC. See Manual for further Details and Parts List. Firmware/Software (changelog...) rcjoy3.3.4.zip (sources and binaries) rcjoy3.3.3.zip (sources and binaries) rcjoy3.3.2.zip (sources and binaries) (Older Software Versions...) Before downloading any file from this page, please, read Legal Stuff Page here click here to view thanks page... PS: DISCONNECT the device from USB before connecting it to the programmer to avoid any possible damages. Manual/Documentation RCJoyNG2_manual.zip (pdf)       (last updated on 27 Mar 2008)