RcJoy NG Interface RcJoy NG Layout (zip) RcJoy NG Schematic (zip) RcJoy NG Top (zip) RcJoy NG Bottom (zip) On this page you can find a little project to build an interface to connect a Radio Controller Trasmitter to your computer via USB port. With this interface your favourite flight simulator will see the RC TX like a traditional joystick. There is no need of additional drivers to use this interface! RcJoystick NG is the same project as RcJoystick but uses the new USB Chips from Microchip® PIC18F2455/2550 that have flash program memory. You should be able to program this chips with our PicProgrammer and WinPic800 Software. View DETAIL PAGE for further Information. Firmware rcjoy2.0.zip (sources and binaries) To view RcJoy NG parts list click here Before downloading any file from this page, please, read Legal Stuff Page here The Firmware is based on Bradley A. Minch Firmware that you can find at http://pe.ece.olin.edu/ece/projects.html NOTE on programming: DISCONNECT the device from USB port before connecting it to the programmer to avoid possible damages to your programmer or computer.